xt-8 tumble

Overview
xt-8 makes notes that bounce and fall. It plays a loop of random notes that repeats, and can change a little on each pass, a lot, or not at all.
Header bar
| Control | What it does |
|---|---|
| patch, random, back | The shared module buttons. See The rack. |
| change, spread, bias, chance | The four parameters as values. Drag them, or drag in the display. |
| Bypass (power icon) | Plays the incoming notes straight. |
Display
The ring at the left holds the loop, one dot for each step. Drag the center of the ring up or down for change, and left or right for the loop length, or scroll. Click a dot to write it, or drag to paint. The curve in the middle shows where the pitches come from: drag it left or right for spread, and up or down for bias. The bar next to it is the pitch range: drag an end, or drag the middle to move it. The rows on the right set where velocity, length, time and octave come from: click to switch between fixed and random. The tape at the far right shows the notes: drag it up or down for chance.
Parameters
| Parameter | Range / values | What it does |
|---|---|---|
| change | locked, flip 1% to 99%, random. Default flip 1%. | Locked repeats the loop forever. A little lets it drift slowly. All the way is pure random. |
| spread | narrow, bell, flat or edges. Default bell. | The shape the pitches are drawn from. Narrow stays in one place, flat uses the whole range, edges jumps between low and high. |
| bias | -100 to +100. Default 0. | Pushes the pitches up or down inside the range. |
| chance | 0% to 100%. Default 62%. | How many steps play a note. |